Cisco 5510 - ASA SSL / IPsec VPN Edition User Manual

CHAPTER
1-1
Cisco ASA Series CLI Configuration Guide
1
Adding an EtherType Access List
This chapter describes how to configure EtherType access lists and includes the following sections:
• Information About EtherType Access Lists, page 1-1
• Licensing Requirements for EtherType Access Lists, page 1-1
• Guidelines and Limitations, page 1-2
• Default Settings, page 1-2
• Configuring EtherType Access Lists, page 1-2
• Monitoring EtherType Access Lists, page 1-4
• What to Do Next, page 1-4
• Configuration Examples for EtherType Access Lists, page 1-5
• Feature History for EtherType Access Lists, page 1-5
Information About EtherType Access Lists
An EtherType access list is made up of one or more Access Control Entries (ACEs) that specify an
EtherType. An EtherType rule controls any EtherType identified by a 16-bit hexadecimal number, as well
as selected traffic types. See the “Supported EtherTypes and Other Traffic” section on page 1-5 for more
information.
For information about creating an access rule with the EtherType access list, see Chapter 1, “Configuring
Access Rules.”
Licensing Requirements for EtherType Access Lists
The following table shows the licensing requirements for this feature:
Model License Requirement
All models Base License.

Cisco 5510 - ASA SSL / IPsec VPN Edition Specifications

General

Brand	Cisco
Model	5510 - ASA SSL / IPsec VPN Edition
Category	Firewall
Language	English