1-5
Cisco ASA Series CLI Configuration Guide
Chapter 1 Adding a Standard Access Control List
Feature History for Standard Access Lists
The following example shows how to permit IP traffic through the ASA if conditions are matched:
hostname(config)# access-list 77 standard permit
The following example shows how to specify a destination address:
hostname(config)# access-list 77 standard permit host 10.1.10.123
Feature History for Standard Access Lists
Table 1-2 lists the release history for this feature.
Table 1-2 Feature History for Standard Access Lists
Feature Name Releases Feature Information
Standard access lists 7.0(1) Standard access listsidentify the destination IP addresses of
OSPF routes, which can be used in a route map for OSPF
redistribution.
We introduced the feature and the following command:
access-list standard.
To Next Page
Loading...
Need help?
General
