Cisco 5510 - ASA SSL / IPsec VPN Edition User Manual

1-35
Cisco ASA Series CLI Configuration Guide
Chapter 1 Starting Interface Configuration (ASA 5510 and Higher)
Where to Go Next
Subinterface Parameters Example
The following example configures parameters for a subinterface in single mode:
interface gigabitethernet 0/1.1
vlan 101
no shutdown
Multiple Context Mode Example
The following example configures interface parameters in multiple context mode for the system
configuration, and allocates the gigabitethernet 0/1.1 subinterface to contextA:
interface gigabitethernet 0/1
speed 1000
duplex full
no shutdown
interface gigabitethernet 0/1.1
vlan 101
context contextA
allocate-interface gigabitethernet 0/1.1
EtherChannel Example
The following example configures three interfaces as part of an EtherChannel. It also sets the system
priority to be a higher priority, and GigabitEthernet 0/2 to be a higher priority than the other interfaces
in case more than eight interfaces are assigned to the EtherChannel.
lacp system-priority 1234
interface GigabitEthernet0/0
channel-group 1 mode active
interface GigabitEthernet0/1
channel-group 1 mode active
interface GigabitEthernet0/2
lacp port-priority 1234
channel-group 1 mode passive
interface Port-channel1
lacp max-bundle 4
port-channel min-bundle 2
port-channel load-balance dst-ip
Where to Go Next
• For multiple context mode:
a. Assign interfaces to contexts and automatically assign unique MAC addresses to context
interfaces. See Chapter 1, “Configuring Multiple Context Mode.”
b. Complete the interface configuration according to Chapter 1, “Completing Interface
Configuration (Routed Mode),” or Chapter 1, “Completing Interface Configuration
(Transparent Mode).”

Cisco 5510 - ASA SSL / IPsec VPN Edition Specifications

General

Brand	Cisco
Model	5510 - ASA SSL / IPsec VPN Edition
Category	Firewall
Language	English