Cisco 5510 - ASA SSL / IPsec VPN Edition User Manual

1-11
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring the ASA CX Module
Configuring the ASA CX Module
What to Do Next
• (Optional) Configure the authentication proxy port. See the “(Optional) Configuring the
Authentication Proxy Port” section on page 1-11.
• Divert traffic to the ASA CX module. See the “Redirecting Traffic to the ASA CX Module” section
on page 1-12.
(Optional) Configuring the Authentication Proxy Port
The default authentication port is 885. To change the authentication proxy port, perform the following
steps. For more information about the authentication proxy, see the “Information About Authentication
Proxy” section on page 1-3.
Note You can also set the port as part of the ASDM startup wizard. See the “Configuring Basic ASA CX
Settings at the ASA CX CLI” section on page 1-8.
Detailed Steps
Command Purpose
cxsc auth-proxy port port
Example:
hostname(config)# cxsc auth-proxy port 5000
Sets the authentication proxy port greater than 1024. The default
is 885.

Cisco 5510 - ASA SSL / IPsec VPN Edition Specifications

General

Brand	Cisco
Model	5510 - ASA SSL / IPsec VPN Edition
Category	Firewall
Language	English