CHAPTER
1-1
Cisco ASA Series CLI Configuration Guide
1
Adding a Standard Access Control List
This chapter describes how to configure a standard access list and includes the following sections:
• Information About Standard Access Lists, page 1-1
• Licensing Requirements for Standard Access Lists, page 1-1
• Guidelines and Limitations, page 1-1
• Default Settings, page 1-2
• Adding Standard Access Lists, page 1-3
• What to Do Next, page 1-4
• Monitoring Access Lists, page 1-4
• Configuration Examples for Standard Access Lists, page 1-4
• Feature History for Standard Access Lists, page 1-5
Information About Standard Access Lists
Standard access lists identify the destination IP addresses of OSPF routes and can be used in a route map
for OSPF redistribution. Standard access lists cannot be applied to interfaces to control traffic.
Licensing Requirements for Standard Access Lists
The following table shows the licensing requirements for this feature:
Guidelines and Limitations
This section includes the guidelines and limitations for this feature:
• Context Mode Guidelines, page 1-2
• Firewall Mode Guidelines, page 1-2
Model License Requirement
All models Base License.
To Next Page
Loading...
Need help?
General
