1-15
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring the ASA CX Module
Monitoring the ASA CX Module
Shutting Down the Module
If you restart the ASA, the module is not automatically restarted. To shut down the module, perform the
following steps at the ASA CLI.
Detailed Steps
Monitoring the ASA CX Module
• Showing Module Status, page 1-15
• Showing Module Statistics, page 1-16
• Monitoring Module Connections, page 1-17
• Capturing Module Traffic, page 1-20
• Debugging the Module, page 1-20
Note For ASA CX-related syslog messages, see the syslog messages guide. ASA CX syslog messages start
with message number 429001.
Showing Module Status
To check the status of a module, enter one of the following commands:
Examples
The following is sample output from the show module command for an ASA with an ASA CX SSP
installed:
hostname# show module
Mod Card Type Model Serial No.
--- -------------------------------------------- ------------------ -----------
0 ASA 5585-X Security Services Processor-10 wi ASA5585-SSP-10 JAF1507AMKE
1 ASA 5585-X CX Security Services Processor-10 ASA5585-SSP-CX10 JAF1510BLSA
Mod MAC Address Range Hw Version Fw Version Sw Version
Command Purpose
hw-module module 1 shutdown
Example:
hostname# hw-module module 1 shutdown
Shuts down the module.
Command Purpose
show module
Displays the status.
show module 1 details
Displays additional status information.
To Next Page
Loading...
Need help?
General
