1-17
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Inspection for Voice and Video Protocols
RTSP Inspection
Where class_map_name is the name of the class map. The match-all keyword is the default, and
specifies that traffic must match all criteria to match the class map. The match-any keyword
specifies that the traffic matches the class map if it matches at least one of the criteria. The CLI
enters class-map configuration mode, where you can enter one or more match commands.
b. (Optional) To add a description to the class map, enter the following command:
hostname(config-cmap)# description string
c. (Optional) To match an RTSP request method, enter the following command:
hostname(config-cmap)# match [not] request-method method
Where method is the type of method to match (announce, describe, get_parameter, options, pause,
play, record, redirect, setup, set_parameter, teardown).
d. (Optional) To match URL filtering, enter the following command:
hostname(config-cmap)# match [not] url-filter regex {class class_name | regex_name}
Where the regex regex_name argument is the regular expression you created in Step 1. The class
regex_class_name is the regular expression class map you created in Step 2.
Step 4 To create an RTSP inspection policy map, enter the following command:
hostname(config)# policy-map type inspect rtsp policy_map_name
hostname(config-pmap)#
Where the policy_map_name is the name of the policy map. The CLI enters policy-map configuration
mode.
Step 5 (Optional) To add a description to the policy map, enter the following command:
hostname(config-pmap)# description string
Step 6 To apply actions to matching traffic, perform the following steps.
a. Specify the traffic on which you want to perform actions using one of the following methods:
• Specify the RTSP class map that you created in Step 3 by entering the following command:
hostname(config-pmap)# class class_map_name
hostname(config-pmap-c)#
• Specify traffic directly in the policy map using one of the match commands described in Step 3.
If you use a match not command, then any traffic that does not match the criterion in the match
not command has the action applied.
b. Specify the action you want to perform on the matching traffic by entering the following command:
hostname(config-pmap-c)# {[drop [send-protocol-error] |
drop-connection [send-protocol-error]| mask | reset] [log] | rate-limit message_rate}
Not all options are available for each match or class command. See the CLI help or the command
reference for the exact options available.
The drop keyword drops all packets that match.
The send-protocol-error keyword sends a protocol error message.
The drop-connection keyword drops the packet and closes the connection.
The mask keyword masks out the matching portion of the packet.
The reset keyword drops the packet, closes the connection, and sends a TCP reset to the server
and/or client.
To Next Page
Loading...
Need help?
General
