Cisco 5510 - ASA SSL / IPsec VPN Edition User Manual

1-26
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring Connection Profiles, Group Policies, and Users
Configuring Connection Profiles
Url specifies a URL or IP address for this tunnel group.
For example, to enable the group URLs http://www.example.com and http://192.168.10.10 for the
tunnel-group named RadiusServer, enter the following commands:
hostname(config)# tunnel-group RadiusServer type webvpn
hostname(config)# tunnel-group RadiusServer general-attributes
hostname(config-tunnel-general)# authentication server-group RADIUS
hostname(config-tunnel-general)# accounting-server-group RADIUS
hostname(config-tunnel-general)# tunnel-group RadiusServer webvpn-attributes
hostname(config-tunnel-webvpn)# group-alias “Cisco Remote Access” enable
hostname(config-tunnel-webvpn)# group-url http://www.example.com enable
hostname(config-tunnel-webvpn)# group-url http://192.168.10.10 enable
hostname(config-tunnel-webvpn)#
For a more extensive example, see Customizing Login Windows for Users of Clientless SSL VPN
Sessions, page 70-27.
Step 6 To exempt certain users from running Cisco Secure Desktop on a per connection profile basis if they
enter one of the group-urls, enter the following command:
hostname(config-tunnel-webvpn)# without-csd
hostname(config-tunnel-webvpn)#
Note Entering this command prevents the detection of endpoint conditions for these sessions, so you
may need to adjust the dynamic access policy (DAP) configuration.
Step 7 To specify the DNS server group to use for a connection profile for clientless SSL VPN sessions, use the
dns-group command. The group you specify must be one you already configured in global configuration
mode (using the dns server-group and name-server commands).
By default, the connection profile uses the DNS server group DefaultDNS. However, this group must be
configured before the security appliance can resolve DNS requests.
The following example configures a new DNS server group named corp_dns and specifies that server
group for the connection profile telecommuters:
hostname(config)# dns server-group corp_dns
hostname(config-dns-server-group)# domain-name cisco.com
hostname(config-dns-server-group)# name-server 209.165.200.224
hostname(config)# tunnel-group telecommuters webvpn-attributes
hostname(config-tunnel-webvpn)# dns-group corp_dns
hostname(config-tunnel-webvpn)#
Step 8 (Optional) To enable extracting a username from a client certificate for use in authentication and
authorization, use the pre-fill-username command in tunnel-group webvpn-attributes mode. There is no
default value.
hostname(config)# pre-fill-username {ssl-client | clientless}
The pre-fill-username command enables the use of a username extracted from the certificate field
specified in the username-from-certificate command (in tunnel-group general-attributes mode) as the
username for username/password authentication and authorization. To use this pre-fill username from
certificate feature, you must configure both commands.
Note In Version 8.0.4, the username is not pre-filled; instead, any data sent in the username field is
ignored.

Cisco 5510 - ASA SSL / IPsec VPN Edition Specifications

General

Brand	Cisco
Model	5510 - ASA SSL / IPsec VPN Edition
Category	Firewall
Language	English