Cisco 5510 - ASA SSL / IPsec VPN Edition User Manual

1-31
Cisco ASA Series CLI Configuration Guide
Chapter 1 Configuring OSPF
Configuring OSPFv3
To change the interval at which OSPFv3 LSAs are collected into a group and refreshed, check summed,
or aged, perform the following steps:
Detailed Steps
To configure LSA retransmission packet pacing, perform the following steps:
Detailed Steps
Command Purpose
Step 1
ipv6 router ospf process-id
Example:
hostname(config-if)# ipv6 router ospf 1
Enables an OSPFv3 routing process and enters IPv6 router
configuration mode.
The process-id argument is an internally used identifier for this
routing process, is locally assigned, and can be any positive
integer from 1 to 65535. This ID does not have to match the ID on
any other device; it is for internal administrative use only. You can
use a maximum of two processes.
Step 2
timers pacing lsa-group seconds
Example:
hostname(config-rtr)# timers pacing
lsa-group 300
Changes the interval at which OSPFv3 LSAs are collected into a
group and refreshed, checksummed, or aged.
The seconds argument specifies the number of seconds in the
interval at which LSAs are grouped, refreshed, check summed, or
aged. The range is from 10 to 1800 seconds. The default value is
240 seconds.
Command Purpose
Step 1
ipv6 router ospf process-id
Example:
hostname(config-if)# ipv6 router ospf 1
Enables an OSPFv3 routing process and enters IPv6 router
configuration mode.
The process-id argument is an internally used identifier for this
routing process, is locally assigned, and can be any positive
integer from 1 to 65535. This ID does not have to match the ID on
any other device; it is for internal administrative use only. You can
use a maximum of two processes.
Step 2
timers pacing retransmission milliseconds
Example:
hostname(config-rtr)# timers pacing
retransmission 100
Configures LSA retransmission packet pacing.
The milliseconds argument specifies the time in milliseconds at
which LSAs in the retransmission queue are paced. The
configurable range is from 5 to 200 milliseconds. The default
value is 66 milliseconds.

Cisco 5510 - ASA SSL / IPsec VPN Edition Specifications

General

Brand	Cisco
Model	5510 - ASA SSL / IPsec VPN Edition
Category	Firewall
Language	English