For non-802.1x authentication, WPA-PSK or WPA2-PSK is required.
• If using open authentication plus WEP encryption or shared key authentication, enter the static WEP key information
that matches the access point configuration.
Note: CCKM will be negotiated if enabled on the access point when using 802.1x authentication with LEAP, EAP-FAST, EAP-
TLS, PEAP or AKM modes.
WEP with AKM is only applicable with 802.1x authentication (not WPA-PSK/WPA2-PSK).
If using 802.1x authentication via LEAP, EAP-FAST, PEAP or AKM (authenticated key-management) authentication modes,
then a username and password must be configured. AKM mode will use LEAP as the 802.1x method.
• Select whether to use Dynamic Host Configuration Protocol (DHCP) or configure static IP information.
• If option 150 or 66 is not configured to provide the TFTP server IP address via the network’s DHCP scope, then enter
the TFTP server IP address info.
• To enable PEAP with server validation, select Validate Server Certificate after importing the authentication server
certificate.
• When using EAP-TLS, select either Manufacturing Issued or User Installed for the Client EAP-TLS Certificate
option after selecting EAP-TLS.
Note: WEP128 is listed as WEP104 on the Cisco Unified Wireless LAN Controllers.
To Next Page
Loading...
