SUMMARY STEPS
1.
configure
2.
router bgp as-number
3.
address-family ipv4 unicast
4.
exit
5.
neighbor-group name
6.
tcp mss segment-size
7.
address-family ipv4 unicast
8.
exit
9.
exit
10.
neighbor ip-address
11.
remote-as as-number
12.
use neighbor-group group-name
13.
tcp mss inheritance-disable
14.
address-family ipv4 unicast
15.
commit
DETAILED STEPS
PurposeCommand or Action
Enters Global Configuration mode.configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 1
Specifies the autonomous system number and enters the
BGP configuration mode, allowing you to configure the
BGP routing process.
router bgp as-number
Example:
RP/0/RSP0/CPU0:router(config)# router bgp 10
Step 2
Specifies the IPv4 address family unicast and enters address
family configuration mode.
address-family ipv4 unicast
Example:
RP/0/RSP0/CPU0:router(config-bgp)#
address-family ipv4 unicast
Step 3
Exits router address family configuration mode, and returns
to BGP configuration mode.
exit
Example:
RP/0/RSP0/CPU0:router(config-bgp-af)# exit
Step 4
Enters neighbor group configuration mode.
neighbor-group name
Example:
RP/0/RSP0/CPU0:router(config-bgp)#
neighbor-group n1
Step 5
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
96
Implementing BGP
Disabling Per Neighbor TCP MSS
To Next Page
Loading...
Need help?
General
