DETAILED STEPS
PurposeCommand or Action
Runs on-demand Route Consistency
Checker (RCC) or Label Consistency
Checker (LCC).
Use one of these commands.
Step 1
•
show rcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name]
•
show lcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name]
Example:
RP/0/RSP0/CPU0:router#show rcc ipv6 unicast 2001:DB8::/32 vrf vrf_1
Or
RP/0/RSP0/CPU0:router#show lcc ipv6 unicast 2001:DB8::/32 vrf vrf_1
Clears the log of previous scans.Use one of these commands.
Step 2
•
clear rcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name] log
•
clear lcc {ipv4 | ipv6} unicast [all] [prefix/mask] [vrf vrf-name] log
Example:
RP/0/RSP0/CPU0:router#clear rcc ipv6 unicast log
Or
RP/0/RSP0/CPU0:router#show lcc ipv6 unicast log
Enabling RCC and LCC Background Scan
Perform this task to run a background scan for Route Consistency Checker (RCC) and Label Consistency
Checker (LCC).
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
510
Implementing and Monitoring RIB
Enabling RCC and LCC Background Scan
To Next Page
Loading...
Need help?
General
