PurposeCommand or Action
Configures the coexistence mechanism between BoB and
BLB.
Use one of these commands:
Step 3
•
bundle coexistence bob-blb inherit
• inherit—Use the inherit keyword to configure
"inherited" coexistence mode.
•
bundle coexistence bob-blb logical
Example:
RP/0/RSP0/CPU0:router(config-bfd)#bundle
coexistence bob-blb inherit
• logical—Use the logical keyword to configure
"logical" coexistence mode.
Or
RP/0/RSP0/CPU0:router(config-bfd)#bundle
coexistence bob-blb logical
commit
Step 4
Configuring BFD IPv6 Multihop
Configuring BFD IPv6 Multihop for eBGP Neighbors
Perform this task to configure BFD IPv6 multihop for eBGP neighbors.
SUMMARY STEPS
1.
configure
2.
bfd multipath include location node-id
3.
router bgp as-number
4.
neighbor ip-address ebgp-multihop ttl-value
5.
neighbor ip-address bfd fast-detect
6.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Includes specified line cards to host BFD
multihop sessions.
bfd multipath include location node-id
Example:
RP/0/RSP0/CPU0:router(config)#bfd multipath include
location 0/7/CPU0
Step 2
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
281
Implementing BFD
Configuring BFD IPv6 Multihop
To Next Page
Loading...
Need help?
General
