SetMatchAttributeAttach Point
—
indestinationarea-in
—
indestinationarea-out
n/aindestinationspf-prefix-priority
setn/aspf-priority
n/ais, le, ge, eqtag
Distribute-list in
The distribute-list in attach point within OSPF allows use of route policies to filter OSPF prefixes. The
distribute-list in route-policy can be configured at OSPF instance, area, and interface levels. The route-policy
used in the distribute-list in command supports match statements, "destination" and "rib-metric". The "set"
commands are not supported in the route-policy.
These are examples of valid route-policies for "distribute-list in":
route-policy DEST
if destination in (10.10.10.10/32) then
drop
else
pass
endif
end-policy
route-policy METRIC
if rib-metric ge 10 and rib-metric le 19 then
drop
else
pass
endif
end-policy
prefix-set R-PFX
10.10.10.30
end-set
route-policy R-SET
if destination in R-PFX and rib-metric le 20 then
pass
else
drop
endif
end-policy
OSPFv3 Policy Attach Points
This section describes each of the OSPFv3 policy attach points and provides a summary of the OSPFv3
attributes and operators.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
596
Implementing Routing Policy
Attach Points
To Next Page
Loading...
Need help?
General
