PurposeCommand or Action
Configuring BGP Link-State
Configuring BGP Link-state
To exchange BGP link-state (LS) information with a BGP neighbor, perform these steps:
SUMMARY STEPS
1.
configure
2.
router bgp as-number
3.
neighbor ip-address
4.
remote-as as-number
5.
address-family link-state link-state
6.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Specifies the BGP AS number and enters the BGP
configuration mode, allowing you to configure the BGP
routing process.
router bgp as-number
Example:
RP/0/RSP0/CPU0:router(config)# router bgp 100
Step 2
Configures a CE neighbor. The ip-address argument
must be a private address.
neighbor ip-address
Example:
RP/0/RSP0/CPU0:router(config-bgp)# neighbor
Step 3
10.0.0.2
Configures the remote AS for the CE neighbor.
remote-as as-number
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)# remote-as
Step 4
1
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
169
Implementing BGP
Configuring BGP Link-State
To Next Page
Loading...
Need help?
General
