Configuring a Static Route Between PE-CE Routers: Example
In the following example, a static route between PE and CE routers is configured, and a VRF is associated
with the static route:
configure
router static
vrf vrf_A
address-family ipv4 unicast
0.0.0.0/0 2.6.0.2 120
end
Additional References
The following sections provide references related to implementing Static Routes.
Related Documents
Document TitleRelated Topic
Static Routing Commands in Cisco ASR 9000 Series
Aggregation Services Router Routing Command
Reference
Static routes commands: complete command syntax,
command modes, command history, defaults, usage
guidelines, and examples
Cisco ASR 9000 Series Aggregation Services Router
MPLS Configuration Guide
MPLS Layer 3 VPN configuration: configuration
concepts, task, and examples
Standards
TitleStandards
—
No new or modified standards are supported by this
feature, and support for existing standards has not
been modified by this feature.
MIBs
MIBs LinkMIBs
To locate and download MIBs using Cisco IOS XR
software, use the Cisco MIB Locator found at the
following URL and choose a platform under the Cisco
Access Products menu: http://cisco.com/public/
sw-center/netmgmt/cmtk/mibs.shtml
—
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
644
Implementing Static Routes
Configuring a Static Route Between PE-CE Routers: Example
To Next Page
Loading...
Need help?
General
