PurposeCommand or Action
Specifies either an IPv4 or IPv6 address family unicast and
enters address family configuration submode.
address-family { ipv4 | ipv6 } unicast
Example:
RP/0/RSP0/CPU0:router(config-bgp)#
address-family ipv4 unicast
Step 3
To see a list of all the possible keywords and arguments
for this command, use the CLI help (?).
Sets the critical next-hop trigger delay.
nexthop trigger-delay { critical delay | non-critical
delay }
Step 4
Example:
RP/0/RSP0/CPU0:router(config-bgp-af)# nexthop
trigger-delay critical 15000
commit
Step 5
Disabling Next-Hop Processing on BGP Updates
Perform this task to disable next-hop calculation for a neighbor and insert your own address in the next-hop
field of BGP updates. Disabling the calculation of the best next hop to use when advertising a route causes
all routes to be advertised with the network device as the next hop.
Next-hop processing can be disabled for address family group, neighbor group, or neighbor address family.Note
SUMMARY STEPS
1.
configure
2.
router bgp as-number
3.
neighbor ip-address
4.
remote-as as-number
5.
address-family { ipv4 | ipv6 } unicast
6.
next-hop-self
7.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
114
Implementing BGP
Disabling Next-Hop Processing on BGP Updates
To Next Page
Loading...
Need help?
General
