SUMMARY STEPS
1.
configure
2.
router isis instance-id
3.
address-family {ipv4 | ipv6} [unicast | multicast]
4.
monitor-convergence
5.
prefix-list prefix-list-name
6.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Enables IS-IS routing for the specified routing
instance, and places the router in router
configuration mode.
router isis instance-id
Example:
RP/0/RSP0/CPU0:router(config)#router isis isp
Step 2
Enter the IS-IS address-family configuration
mode.
address-family {ipv4 | ipv6} [unicast | multicast]
Example:
RP/0/RSP0/CPU0:router(config-isis)#address-family ipv6
unicast
Step 3
Enables route convergence monitoring for
IS-IS protocol.
monitor-convergence
Example:
RP/0/RSP0/CPU0:router(config-isis-af)#monitor-convergence
Step 4
Enables individual prefix monitoring for IS-IS
prefixes.
prefix-list prefix-list-name
Example:
RP/0/RSP0/CPU0:router(config-isis-af-rcmd)#prefix-list
isis_monitor
Step 5
commit
Step 6
Enable RCMD Monitoring for OSPF Prefixes
Perform this task to enable individual prefix monitoring for OSPF prefixes.
Before You Begin
To enable monitoring of individual prefixes, first configure a prefix-list using the {ipv4 | ipv6} prefix-list
command. Then, use this prefix list with the prefix-list command.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
652
Implementing RCMD
Enable RCMD Monitoring for OSPF Prefixes
To Next Page
Loading...
Need help?
General
