PurposeCommand or Action
for large
configurations.
Status report: node0_RSP0_CPU0: START TO BACKUP
Status report: node0_RSP0_CPU0: BACKUP HAS COMPLETED
SUCCESSFULLY
[Done]
Proceed with reload? [confirm]RP/0/RSP0/CPU0::This node received
reload
Exits administrator mode and enters
EXEC mode.
exit
Example:
RP/0/RSP0/CPU0:router(admin)#exit
Step 8
Verifies if selective VRF download
is active by confirming that svd roles
show svd role
Example:
RP/0/RSP0/CPU0:router#show svd role
Tue Feb 12 07:50:26.908 UTC
Step 9
are "customer facing" for the line
cards that have VRF interfaces on
them.
Codes: (C) : user Configured role
Node Name IPv4 Role IPv6 Role
--------------------------------------------------------------------
0/RSP0/CPU0 Standard Standard
0/0/CPU0 Customer Facing Not Interested
0/1/CPU0 Customer Facing Not Interested
What to Do Next
After enabling SVD using the svd platform enable command, do not use the selective-vrf-download disable
to turn off SVD.
Disabling Selective VRF Download
Selective VRF Download is disabled by default. However, if the SVD is enabled, perform these tasks to
disable the functionality.
SUMMARY STEPS
1.
admin
2.
configure
3.
no svd platform enable
4.
commit
5.
show svd state
6.
admin
7.
reload location all
8.
exit
9.
show svd role
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
179
Implementing BGP
Disabling Selective VRF Download
To Next Page
Loading...
Need help?
General
