PurposeCommand or Action
Distributes BGP link-state information to the specified
neighbor.
address-family link-state link-state
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)#
Step 5
address-family link-state link-state
commit
Step 6
Configuring Domain Distinguisher
To configure unique identifier four-octet ASN, perform these steps:
SUMMARY STEPS
1.
configure
2.
router bgp as-number
3.
address-family link-state link-state
4.
domain-distinguisher unique-id
5.
commit
DETAILED STEPS
PurposeCommand or Action
configure
Step 1
Specifies the BGP AS number and enters the BGP
configuration mode, allowing you to configure the
BGP routing process.
router bgp as-number
Example:
RP/0/RSP0/CPU0:router(config)# router bgp 100
Step 2
Enters address-family link-state configuration mode.address-family link-state link-state
Example:
RP/0/RSP0/CPU0:router(config-bgp)# address-family
Step 3
link-state link-state
Configures unique identifier four-octet ASN. Range
is from 1 to 4294967295.
domain-distinguisher unique-id
Example:
RP/0/RSP0/CPU0:router(config-bgp-af)#
Step 4
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
170
Implementing BGP
Configuring BGP Link-State
To Next Page
Loading...
Need help?
General
