Disabling BGP Flowspec
This procedure disables BGP flowspec policy on an interface.
SUMMARY STEPS
1.
configure
2.
interface type interface-path-id
3.
{ ipv4 } flowspec disable
4.
commit
DETAILED STEPS
Step 1
configure
Step 2
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface GigabitEthernet 0/1/1/1
Configures an interface and enters the interface configuration mode.
Step 3
{ ipv4 } flowspec disable
Example:
RP/0/RSP0/CPU0:router(config-if)# ipv4 flowspec disable
Disable flowspec policy on the selected interface.
Step 4
commit
Disable flowspec on the interface
The following example shows you how you can disable BGP flowspec on an interface, and apply another
PBR policy:
Interface GigabitEthernet 0/0/0/0
flowspec [ipv4] disable
int g0/0/0/1
service policy type pbr test_policy
!
!
Disable Flowspec Redirect and Validation
You can disable flowspec validation as a whole for eBGP sessions by means of configuring an explicit knob.
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
223
Implementing BGP Flowspec
Disabling BGP Flowspec
To Next Page
Loading...
Need help?
General
