Where to Go Next
To implement more IP routing protocols, see the following document modules in Cisco ASR 9000 Series
Aggregation Services Router Routing Configuration Guide:
•
Implementing OSPF
•
Implementing BGP
•
Implementing EIGRP
•
Implementing RIP
Additional References
The following sections provide references related to implementing IS-IS.
Related Documents
Document TitleRelated Topic
Cisco ASR 9000 Series Aggregation Services Router
Routing Command Reference
IS-IS commands: complete command syntax,
command modes, command history, defaults, usage
guidelines, and examples
Implementing MPLS Traffic Engineering on Cisco
ASR 9000 Series Router module in Cisco ASR 9000
Series Aggregation Services Router MPLS
Configuration Guide
MPLS TE feature information
Intermediate System-to-Intermediate System (IS-IS)
TLVs at: http://www.cisco.com/en/US/tech/tk365/
technologies_tech_note09186a0080094bbd.shtml
IS-IS TLVs
Cisco ASR 9000 Series Aggregation Services Router
Interface and Hardware Component Configuration
Guide and Cisco ASR 9000 Series Aggregation
Services Router Interface and Hardware Component
Command Reference
Bidirectional Forwarding Detection (BFD)
Standards
TitleStandards
Routing IPv6 with IS-IS, by Christian E. Hopps
Draft-ietf-isis-ipv6-05.txt
M-ISIS: Multi Topology (MT) Routing in IS-IS, by
Tony Przygienda, Naiming Shen, and Nischal Sheth
Draft-ietf-isis-wg-multi-topology-06.txt
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
402
Implementing IS-IS
Where to Go Next
To Next Page
Loading...
Need help?
General
