Where to Go Next 498
Additional References 498
CHAPTER 8
Implementing and Monitoring RIB 501
Prerequisites for Implementing RIB 502
Information About RIB Configuration 502
Overview of RIB 502
RIB Data Structures in BGP and Other Protocols 502
RIB Administrative Distance 503
RIB Support for IPv4 and IPv6 503
RIB Statistics 504
IPv6 Provider Edge IPv6 and IPv6 VPN Provider Edge Transport over MPLS 504
RIB Quarantining 504
Route and Label Consistency Checker 505
How to Deploy and Monitor RIB 506
Verifying RIB Configuration Using the Routing Table 506
Verifying Networking and Routing Problems 507
Disabling RIB Next-hop Dampening 508
Configuring RCC and LCC 509
Enabling RCC and LCC On-demand Scan 509
Enabling RCC and LCC Background Scan 510
BGP-RIB Feedback Mechanism for Update Generation 512
Configuration Examples for RIB Monitoring 512
Output of show route Command: Example 512
Output of show route backup Command: Example 513
Output of show route best-local Command: Example 513
Output of show route connected Command: Example 513
Output of show route local Command: Example 514
Output of show route longer-prefixes Command: Example 514
Output of show route next-hop Command: Example 514
Enabling RCC and LCC: Example 515
Where to Go Next 515
Additional References 516
CHAPTER 9
Implementing RIP 519
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
xxi
Contents
To Next Page
Loading...
Need help?
General
