PurposeCommand or Action
Specifies the autonomous system number of
the routing process to configure an EIGRP
routing process.
router eigrp as-number
Example:
RP/0/RSP0/CPU0:router(config)# router eigrp 100
Step 2
Enters an address family configuration mode.address-family [ ipv4 ]
Example:
RP/0/RSP0/CPU0:router(config-eigrp)# address-family ipv4
Step 3
Enables the logging of changes in EIGRP
neighbor adjacencies.
log-neighbor-changes
Example:
RP/0/RSP0/CPU0:router(config-eigrp-af)#
log-neighbor-changes
Step 4
Enables the logging of EIGRP neighbor
warning messages.
log-neighbor-warnings
Example:
RP/0/RSP0/CPU0:router(config-eigrp-af)#
log-neighbor-warnings
Step 5
commit
Step 6
Deletes EIGRP and VPN neighbor entries from
the appropriate table.
clear eigrp [ as-number ] [ vrf { vrf | all }] [ ipv4 ] neighbors
[ ip-address | type interface-path-id ]
Example:
RP/0/RSP0/CPU0:routerr# clear eigrp 20 neighbors
GigabitEthernet 0/1/0/0
Step 7
Deletes EIGRP and VRF topology entries from
the appropriate tab.
clear eigrp [ as-number ] [ vrf { vrf | all }] [ ipv4 ] topology
[ prefix mask ] [ prefix / length ]
Example:
RP/0/RSP0/CPU0:router# clear eigrp topology
Step 8
Displays prefix accounting information for
EIGRP processes.
show eigrp [ as-number ] [ vrf { vrf | all }] [ ipv4 ] accounting
Example:
RP/0/RSP0/CPU0:router# show eigrp vrf all accounting
Step 9
Displays information about interfaces
configured for EIGRP.
show eigrp [ as-number ] [ vrf { vrf | all }][ ipv4 ] interfaces
[ type interface-path-id ] [ detail ]
Example:
RP/0/RSP0/CPU0:router# show eigrp interfaces detail
Step 10
Cisco ASR 9000 Series Aggregation Services Router Routing Configuration Guide, Release 5.3.x
328
Implementing EIGRP
Monitoring EIGRP Routing
To Next Page
Loading...
Need help?
General
