Step 2
Unplug the power cable from the power supply as shown in the below figure.
Step 3
Press the retaining latch towards the pull handle, grasp the handle with one hand, and pull the power supply out of the
slot while supporting the weight of the power supply with the other hand, as shown in the below figure.
Figure 9: Removing the AC Power Supply Cable in Slot PS1
Figure 10: Removing the AC Power Supply
Retaining latch1
Step 4
Repeat these steps if it is required to remove the other AC power supply.
What to Do Next
This completes the procedure for removing the AC power supplies from the Cisco ASR 1001-X Router.
Cisco ASR 1001-X Router Hardware Installation Guide
93
Removing and Replacing FRUs from the Cisco ASR 1001-X Router
Removing AC Power Supplies from the Cisco ASR 1001-X Router
To Next Page
Loading...
