Cisco ASR 5500 - CHAPTER 10 Initial System Configuration; Basic Configuration

CHAPTER 10
Initial System Configuration
This chapter describes how to configure initial system parameters for the ASR 5500.
It includes the following sections:
•
Basic Configuration, page 97
•
Context-level Security Administrator and Hostname, page 98
•
MIO/UMIO Port Numbering, page 99
•
Configure the Ethernet Management Interface, page 100
•
Configure the System for Remote Access, page 104
•
Configuring SSH Options, page 106
•
Set System Timing, page 109
•
Enable CLI Timestamping, page 112
•
Save the Basic Configuration, page 112
•
Additional Configuration Tasks, page 112
Basic Configuration
After power is applied to the chassis and the ASR 5500 has successfully booted, the command line interface
(CLI) appears on a terminal connected to the Console port of the Master MIO.
The initial configuration requires completing the following tasks via the CLI:
•
Configuring a context-level security administrator and hostname.
•
Configuring the Ethernet interface(s) on the MIO/UMIO.
•
Configuring the system for remote CLI access via Telnet, SSH, or FTP (secured or unsecured).
ASR 5500 Installation Guide
97