CHAPTER 7
Configuring Local Authentication and
Authorization
•
Finding Feature Information, page 107
•
How to Configure Local Authentication and Authorization, page 107
•
Monitoring Local Authentication and Authorization, page 110
•
Additional References, page 110
•
Feature Information for Local Authentication and Authorization, page 111
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
How to Configure Local Authentication and Authorization
Configuring the Switch for Local Authentication and Authorization
You can configure AAA to operate without a server by setting the switch to implement AAA in local mode.
The switch then handles authentication and authorization. No accounting is available in this configuration.
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29048-01 107
To Next Page
Loading...
