EasyManua.ls Logo

Cisco Catalyst 2960-X - How to Configure IP Source Guard; Enabling IP Source Guard

Cisco Catalyst 2960-X
498 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
How to Configure IP Source Guard
Enabling IP Source Guard
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
interface interface-id
4.
ip verify source [mac-check ]
5.
exit
6.
ip source binding mac-address vlan vlan-id ip-address interface interface-id
7.
end
8.
show running-config
9.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password
if prompted.
enable
Example:
Switch> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Specifies the interface to be configured, and enters
interface configuration mode.
interface interface-id
Example:
Switch(config)# interface gigabitethernet 1/0/1
Step 3
Enables IP source guard with source IP address filtering.ip verify source [mac-check ]
Step 4
Example:
Switch(config-if)# ip verify source
(Optional) mac-checkEnables IP Source Guard with
source IP address and MAC address filtering.
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
238 OL-29048-01
Configuring IP Source Guard
How to Configure IP Source Guard

Table of Contents

Other manuals for Cisco Catalyst 2960-X

Related product manuals