EasyManua.ls Logo

Cisco Catalyst 2960-X - Applying a VLAN Map to a VLAN

Cisco Catalyst 2960-X
498 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PurposeCommand or Action
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config
Step 7
startup-config
Related Topics
Configuring VLAN Maps, on page 172
Applying a VLAN Map to a VLAN
Beginning in privileged EXEC mode, follow these steps to apply a VLAN map to one or more VLANs:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
vlan filter mapname vlan-list list
4.
end
5.
show running-config
6.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Switch> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Applies the VLAN map to one or more VLAN IDs.
vlan filter mapname vlan-list list
Step 3
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
176 OL-29048-01
Configuring IPv4 ACLs
Applying a VLAN Map to a VLAN

Table of Contents

Other manuals for Cisco Catalyst 2960-X

Related product manuals