EasyManua.ls Logo

Cisco Catalyst 2960-X - Configuring the DHCP Relay Agent

Cisco Catalyst 2960-X
498 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Configuring the DHCP Relay Agent
Follow these steps to enable the DHCP relay agent on the switch:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
service dhcp
4.
end
5.
show running-config
6.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Switch> enable
Step 1
Enters the global configuration mode.configure terminal
Example:
Switch# configure terminal
Step 2
Enables the DHCP server and relay agent on your switch.
By default, this feature is enabled.
service dhcp
Example:
Switch(config)# service dhcp
Step 3
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 4
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 5
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
218 OL-29048-01
Configuring DHCP
Configuring the DHCP Relay Agent

Table of Contents

Other manuals for Cisco Catalyst 2960-X

Related product manuals