Cisco Catalyst 2960-X - Removing Web-Based Authentication Cache Entries; Monitoring Web-Based Authentication Status

Removing Web-Based Authentication Cache Entries
Follow these steps to remove web-based authentication cache entries:
SUMMARY STEPS
1.
enable
2.
clear ip auth-proxy cache {* | host ip address}
3.
clear ip admission cache {* | host ip address}
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if
prompted.
enable
Example:
Switch> enable
Step 1
Delete authentication proxy entries. Use an asterisk to delete all
cache entries. Enter a specific IP address to delete the entry for
a single host.
clear ip auth-proxy cache {* | host ip address}
Example:
Switch# clear ip auth-proxy cache
Step 2
192.168.4.5
Delete authentication proxy entries. Use an asterisk to delete all
cache entries. Enter a specific IP address to delete the entry for
a single host.
clear ip admission cache {* | host ip address}
Example:
Switch# clear ip admission cache 192.168.4.5
Step 3
Monitoring Web-Based Authentication Status
Use the commands in this topic to display the web-based authentication settings for all interfaces or for specific
ports.
Table 31: Privileged EXEC show Commands
PurposeCommand
Displays the web-based authentication settings for all
interfaces for fastethernet, gigabitethernet, or
tengigabitethernet
show authentication sessions method webauth
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29048-01 387
Configuring Web-Based Authentication
Removing Web-Based Authentication Cache Entries