Cisco Catalyst 2960-X - Configuring the Switch to Use Vendor-Specific RADIUS Attributes

PurposeCommand or Action
Returns to privileged EXEC mode.end
Example:
Switch(config)# end
Step 6
Verifies your entries.show running-config
Example:
Switch# show running-config
Step 7
(Optional) Saves your entries in the configuration file.copy running-config startup-config
Example:
Switch# copy running-config startup-config
Step 8
Related Topics
Identifying the RADIUS Server Host, on page 83
RADIUS Server Host, on page 69
Configuring the Switch to Use Vendor-Specific RADIUS Attributes
Follow these steps to configure the switch to use vendor-specific RADIUS attributes:
SUMMARY STEPS
1.
enable
2.
configure terminal
3.
radius-server vsa send [accounting | authentication]
4.
end
5.
show running-config
6.
copy running-config startup-config
DETAILED STEPS
PurposeCommand or Action
Enables privileged EXEC mode. Enter your password if prompted.enable
Step 1
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29048-01 95
Configuring RADIUS
Configuring the Switch to Use Vendor-Specific RADIUS Attributes