CHAPTER 6
Configuring RADIUS
•
Finding Feature Information, page 57
•
Prerequisites for Configuring RADIUS, page 57
•
Restrictions for Configuring RADIUS, page 58
•
Information about RADIUS, page 59
•
How to Configure RADIUS, page 83
•
Monitoring CoA Functionality, page 101
•
Configuration Examples for Controlling Switch Access with RADIUS, page 102
•
Additional References, page 104
•
Feature Information for RADIUS, page 105
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for Configuring RADIUS
This section lists the prerequisites for controlling Switch access with RADIUS.
General:
•
RADIUS and Authentication, Authorization, and Accounting (AAA) must be enabled to use any of the
configuration commands in this chapter.
•
RADIUS is facilitated through AAA and can be enabled only through AAA commands.
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29048-01 57
To Next Page
Loading...
