Cisco Catalyst 2960-X - Finding Feature Information

CHAPTER 18
Configuring IPv6 First Hop Security
•
Finding Feature Information, page 439
•
Prerequisites for First Hop Security in IPv6, page 439
•
Restrictions for First Hop Security in IPv6, page 440
•
Information about First Hop Security in IPv6, page 440
•
How to Configure an IPv6 Snooping Policy, page 442
•
How to Configure the IPv6 Binding Table Content , page 447
•
How to Configure an IPv6 Neighbor Discovery Inspection Policy, page 449
•
How to Configure an IPv6 Router Advertisement Guard Policy, page 454
•
How to Configure an IPv6 DHCP Guard Policy , page 459
•
How to Configure IPv6 Source Guard, page 464
•
Additional References, page 467
Finding Feature Information
Your software release may not support all the features documented in this module. For the latest caveats and
feature information, see Bug Search Tool and the release notes for your platform and software release. To
find information about the features documented in this module, and to see a list of the releases in which each
feature is supported, see the feature information table at the end of this module.
Use Cisco Feature Navigator to find information about platform support and Cisco software image support.
To access Cisco Feature Navigator, go to http://www.cisco.com/go/cfn. An account on Cisco.com is not
required.
Prerequisites for First Hop Security in IPv6
•
You have configured the necessary IPv6 enabled SDM template.
•
You should be familiar with the IPv6 neighbor discovery feature.
Catalyst 2960-X Switch Security Configuration Guide, Cisco IOS Release 15.0(2)EX
OL-29048-01 439