Cisco CATALYST 2960 - Scheduling a Reload of the Software Image; You can schedule a reload of the software image to occur on the switch at a later time (for example, late at night or during the weekend when the switch is used less), or you can synchronize a reload network-wide (for example, to perform a software upgrade on all switches in the network).

Index
IN-4
Catalyst 2960 Switch Hardware Installation Guide
OL-7075-09
P
pinouts
10/100 ports
B-3
adapters B-7
console port B-8
crossover cables
four twisted-pair, 1000BASE-T ports
B-7
two twisted-pair 10/100 ports B-6
RJ-45-to-DB-25 terminal adapter B-8
RJ-45-to-DB-9 terminal adapter B-8
SFP module B-3
straight-through cables
four twisted-pair 1000BASE-T ports
B-6
two twisted-pair B-6
plug-socket combination warning 2-3
PoE
LED
1-16, 1-17, 1-18
on Catalyst 2960-24PC-L, 24LT-L, and 48PST-L
switches
1-12
warning 3-2
port and interface troubleshooting 4-4
port modes
changing
1-14
LEDs 1-16
See also Mode button
ports
10/100/1000
1-4, 1-11, 1-13, 1-18
dual-purpose 1-13
numbering of 10/100/1000 1-11
numbering of SFP module ports 1-8
POST
LEDs
2-6, 3-5, 4-2, C-4
results 2-6, 3-5, 4-1, C-4
running at power on 2-6, 3-5, 4-2
power
connecting to
2-5, 3-5
connectors 1-19, 1-20
power on 2-5, 3-5
power-on self test
See POST
Power over Ethernet
See PoE
Power over Ethernet
See PoE
power supply
AC power outlet
1-20
for the Catalyst 2960PD-8TT-L switch 1-13
internal 1-20
RPS connector 1-20
power supply warning 2-3, 3-3
procedures
connection
2-14 to 2-20
installation 2-6 to 2-14, 3-5 to 3-18
product disposal warning 2-3, 3-3
R
rack-mounting 2-7 to 2-10, 3-15 to 3-16
rack-mounting warning 2-3, 2-6, 3-2, 3-15
read the wall-mounting instructions warning 2-2, 3-11, 3-17
rear panel
clearance
2-5, 3-4
description 1-19 to 1-21
redundant power supply
See RPS
removing SFP modules
2-17 to 2-18
restricted access area warning 2-3
RJ-45 connector, console port B-4
RJ-45 console port 1-19
RPS
attachment warning
2-2, 2-6
connecting to 2-5, 3-5
connector 1-20
LED 1-16
RPS warning 2-2, 2-13