Index
IN-5
Catalyst 2960 Switch Hardware Installation Guide
OL-7075-09
S
safety warnings 2-2, 3-1
SC connector B-3
security slot 1-21
serial number location 4-6
SFP modules
1000BASE-T supported speeds
1-17
bale-clasp latch removal 2-17
cables B-4
connecting to 2-18 to 2-20
connectors B-3
described 1-13
installation 2-16 to 2-17
shelf-mounting 2-14, 3-6
Simple Network Management Protocol
See SNMP
SNMP network management platforms
1-22
software switch management 1-22
specifications A-1
speed, troubleshooting 4-4
stacking the chassis warning 2-2, 3-2
straight-through cable pinout
four twisted-pair 1000BASE-T ports
B-6
two twisted-pair 10/100 ports B-6
SunNet Manager 1-22
switch descriptions 1-1
switch powering on 2-5, 3-5
system LED 1-15
T
technical specifications A-1
telco racks 2-7, 3-15
Telnet, and accessing the CLI 1-22
temperature, operating A-1
terminal emulation software C-3
trained and qualified personnel warning 2-3
troubleshooting 4-1 to 4-6
bad or damaged cable 4-2
connection problems 4-2
diagnosing problems 4-1
Ethernet and fiber-optic cables 4-3
link status 4-3
ping end device 4-4
port and interface settings 4-4
POST 4-1
spanning tree loops 4-4
speed, duplex, and autonegotiation 4-4
switch performance 4-4
troubleshooting spanning tree loops 4-4
W
wall-mounting 2-11, 3-16
warnings
attaching the Cisco RPS
2-2, 2-6
circuit protection 2-3
class 1 laser product 2-3, 3-2
disconnecting device 2-3
Ethernet cables 2-2, 3-2
Ethernet ports 3-3
ground connection 2-4, 3-3
grounded equipment 2-3, 3-3
installation 2-2, 3-1
installation instructions 2-2, 3-2
jewelry removal 2-2, 3-2
lightning activity 2-2, 3-2
local and national electrical codes compliance 2-4, 3-3
more than one power supply 3-3
no user-serviceable parts 2-4
overheating prevention 2-2, 3-1
plug-socket combination 2-3
PoE 3-2
power supplies 2-3
prevent bodily injury 2-3, 2-6, 3-2, 3-15
product disposal 2-3, 3-3
rack-mounting 2-3, 2-6, 3-2, 3-15
To Next Page
Loading...
