Cisco CATALYST 2960 - VLANs; Default VLAN is VLAN 1. For more information, see Chapter 13, “Configuring VLANs.”; VTP mode is server. For more information, see Chapter 14, “Configuring VTP.”; Voice VLAN is disabled. For more information, see Chapter 15, “Configuring Voice VLAN.”

3-12
Catalyst 2960 Switch Hardware Installation Guide
OL-7075-09
Chapter 3 Switch Installation (8-Port Switches)
Installing the Switch
Figure 3-5 Installing the Mounting Screws on a Wall
Step 4 Attach the screw template to the wall.
Step 5 Use a 0.144-inch (3.7 mm) or a #27 drill bit to drill a 1/2-inch (12.7 mm) hole in the three screw
template slots.
Step 6 Insert three screws in the slots on the screw template, and tighten until they touch the top of the
screw template.
Step 7 Remove the screw template from the wall.
Step 8 Place the switch onto the mounting screws, and slide it down until it locks in place, as shown
in Figure 3-6.
1 Wall 3 Screw template
2 Screws
CABLE SIDE ENTRY
THIS SIDE AWAY FROM
MOUNTING SURFACE
2
3
2
2
1
157828