Index
IN-19
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
interface
number
10-7
range macros 10-10
interface command 10-7 to 10-8
interface configuration mode 2-3
interfaces
auto-MDIX, configuring
10-20
configuring
IPv4 and IPv6
39-15
procedure 10-8
counters, clearing 10-26
default configuration 10-16
described 10-21
descriptive name, adding 10-21
displaying information about 10-25
duplex and speed configuration guidelines 10-17
flow control 10-19
management 1-5
monitoring 10-25
naming 10-21
physical, identifying 10-7
range of 10-9
restarting 10-26
shutting down 10-26
speed and duplex, configuring 10-18
status 10-25
supported 10-7
types of 10-1
interfaces range macro command 10-10
interface types 10-7
Interior Gateway Protocol
See IGP
internal BGP
See IBGP
internal neighbors, BGP
38-49
Internet Control Message Protocol
See ICMP
Internet Group Management Protocol
See IGMP
Internet Protocol version 6
See IPv6
Inter-Switch Link
See ISL
inter-VLAN routing
1-11, 38-2
Intrusion Detection System
See IDS appliances
inventory management TLV
27-6
IP ACLs
for QoS classification
36-7
implicit deny 34-10, 34-14
implicit masks 34-10
named 34-15
undefined 34-21
IP addresses
128-bit
39-2
classes of 38-7
default configuration 38-6
discovering 6-27
for IP routing 38-5
IPv6 39-2
MAC address association 38-9
monitoring 38-18
IP base feature set 1-1
IP broadcast address 38-17
ip cef distributed command 38-81
IP directed broadcasts 38-15
ip igmp profile command 23-25
IP information
assigned
manually
3-10
through DHCP-based autoconfiguration 3-3
default configuration 3-3
IP multicast routing
addresses
all-hosts
44-3
all-multicast-routers 44-3
host group address range 44-3
administratively-scoped boundaries, described 44-39
To Next Page
Loading...
