Cisco Catalyst 3120 User Manual

26-3
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
Chapter 26 Configuring CDP
Configuring CDP
Use the no form of the CDP commands to return to the default settings.
This example shows how to configure CDP characteristics.
Switch# configure terminal
Switch(config)# cdp timer 50
Switch(config)# cdp holdtime 120
Switch(config)# cdp advertise-v2
Switch(config)# end
For additional CDP show commands, see the “Monitoring and Maintaining CDP” section on page 26-5.
Disabling and Enabling CDP
CDP is enabled by default.
Beginning in privileged EXEC mode, follow these steps to disable the CDP device discovery capability:
Beginning in privileged EXEC mode, follow these steps to enable CDP when it has been disabled:
This example shows how to enable CDP if it has been disabled.
Switch# configure terminal
Switch(config)# cdp run
Switch(config)# end
Step 3
cdp holdtime seconds (Optional) Specify the amount of time a receiving device should hold the
information sent by your device before discarding it.
The range is 10 to 255 seconds; the default is 180 seconds.
Step 4
cdp advertise-v2 (Optional) Configure CDP to send Version-2 advertisements.
This is the default state.
Step 5
end Return to privileged EXEC mode.
Step 6
show cdp Verify your settings.
Step 7
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
no cdp run Disable CDP.
Step 3
end Return to privileged EXEC mode.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
cdp run Enable CDP after disabling it.
Step 3
end Return to privileged EXEC mode.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English