Cisco Catalyst 3120 User Manual

21-19
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
Chapter 21 Configuring DHCP Features and IP Source Guard
Displaying IP Source Guard Information
To disable IP source guard with source IP address filtering, use the no ip verify source interface
configuration command.
To delete a static IP source binding entry, use the no ip source global configuration command.
This example shows how to enable IP source guard with source IP and MAC filtering on VLANs 10
and 11:
Switch# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
Switch(config)# interface gigabitethernet1/0/1
Switch(config-if)# ip verify source port-security
Switch(config-if)# exit
Switch(config)# ip source binding 0100.0022.0010 vlan 10 10.0.0.2 interface
gigabitethernet1/0/1
Switch(config)# ip source binding 0100.0230.0002 vlan 11 10.0.0.4 interface
gigabitethernet1/0/1
Switch(config)# end
Displaying IP Source Guard Information
To display the IP source guard information, use one or more of the privileged EXEC commands in
Table 21-3:
Step 8
show ip source binding [ip-address]
[mac-address] [dhcp-snooping | static]
[inteface interface-id] [vlan vlan-id]
Display the IP source bindings on the switch, on a specific VLAN, or on
a specific interface.
Step 9
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
Table 21-3 Commands for Displaying IP Source Guard Information
Command Purpose
show ip source binding Display the IP source bindings on a switch.
show ip verify source Display the IP source guard configuration on the switch.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English