EasyManuals Logo

Cisco Catalyst 3120 User Manual

Cisco Catalyst 3120
1224 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #866 background imageLoading...
Page #866 background image
38-44
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
Chapter 38 Configuring IP Unicast Routing
Configuring BGP
Figure 38-4 EIGRP Stub Router Configuration
For more information about EIGRP stub routing, see “Configuring EIGRP Stub Routing” section of the
Cisco IOS IP Configuration Guide, Volume 2 of 3: Routing Protocols, Release 12.2.
Monitoring and Maintaining EIGRP
You can delete neighbors from the neighbor table. You can also display various EIGRP routing statistics.
Table 38-8 lists the privileged EXEC commands for deleting neighbors and displaying statistics. For
explanations of fields in the resulting display, see the Cisco IOS IP Command Reference, Volume 2 of 3:
Routing Protocols, Release 12.2.
Configuring BGP
The Border Gateway Protocol (BGP) is an exterior gateway protocol used to set up an interdomain
routing system that guarantees the loop-free exchange of routing information between autonomous
systems. Autonomous systems are made up of routers that operate under the same administration and
that run Interior Gateway Protocols (IGPs), such as RIP or OSPF, within their boundaries and that
interconnect by using an Exterior Gateway Protocol (EGP). BGP Version 4 is the standard EGP for
interdomain routing in the Internet. The protocol is defined in RFCs 1163, 1267, and 1771. You can find
detailed information about BGP in Internet Routing Architectures, published by Cisco Press, and in the
“Configuring BGP” chapter in the Cisco IP and IP Routing Configuration Guide.
Host A Host B
Switch B
Switch A
Routed to WAN
Switch C
Host C
145776
Table 38-8 IP EIGRP Clear and Show Commands
Command Purpose
clear ip eigrp neighbors [if-address | interface] Delete neighbors from the neighbor table.
show ip eigrp interface [interface] [as number] Display information about interfaces configured for EIGRP.
show ip eigrp neighbors [type-number] Display EIGRP discovered neighbors.
show ip eigrp topology [autonomous-system-number]|
[[ip-address] mask]]
Display the EIGRP topology table for a given process.
show ip eigrp traffic [autonomous-system-number] Display the number of packets sent and received for all or a
specified EIGRP process.

Table of Contents

Other manuals for Cisco Catalyst 3120

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3120 and is the answer not in the manual?

Cisco Catalyst 3120 Specifications

General IconGeneral
BrandCisco
ModelCatalyst 3120
CategorySwitch
LanguageEnglish

Related product manuals