Cisco Catalyst 3120 User Manual

10-15
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
Chapter 10 Configuring Interface Characteristics
Configuring Ethernet Interfaces
Monitoring the Ethernet Management Port
To display the link status, use the show interfaces fastethernet 0 privileged EXEC command.
TFTP and the Ethernet Management Port
Use the commands in Table 10-1 when using TFTP to download or upload a configuration file to the boot
loader.
Configuring Ethernet Interfaces
These sections contain this configuration information:
• Default Ethernet Interface Configuration, page 10-16
• Configuring Interface Speed and Duplex Mode, page 10-17
• Configuring IEEE 802.3x Flow Control, page 10-19
• Configuring Auto-MDIX on an Interface, page 10-20
• Adding a Description for an Interface, page 10-21
Table 10-1 Boot Loader Commands
Command Description
ARP [ip_address] Displays the currently cached ARP
1
table when this command is entered
without the ip_address parameter.
Enables ARP to associate a MAC address with the specified IP address
when this command is entered with the ip_address parameter.
1. ARP = Address Resolution Protocol.
Mgmt_init Resets the MAC address of the Ethernet management port.
Mgmt_show Displays the statistics for the Ethernet management port.
Mgmt_clr Clears the statistics for the Ethernet management port.
Ping host_ip_address Sends ICMP ECHO_REQUEST packets to the specified network host.
boot tftp:/file-url ... Loads and boots an executable image from the TFTP server and enters
the command-line interface.
For more details, see the command reference for this release.
copy tftp:/source-file-url
filesystem:/destination-file-
url
Copies a Cisco IOS image from the TFTP server to the specified
location.
For more details, see the command reference for this release.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English