42-8
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
Chapter 42 Configuring Enhanced Object Tracking
Configuring Enhanced Object Tracking Features
Configuring Other Tracking Characteristics
You can also use the enhanced object tracking for tracking other characteristics.
• You can track the reachability of an IP route by using the track ip route reachability global
configuration command.
• You can use the track ip route metric threshold global configuration command to determine if a
route is above or below threshold.
• You can use the track resolution global configuration command to change the metric resolution
default values for routing protocols.
• You can use the track timer tracking configuration command to configure the tracking process to
periodically poll tracked objects.
Use the show track privileged EXEC command to verify enhanced object tracking configuration.
For more information about enhanced object tracking and the commands used to configure it, see this
URL:
http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a00801541be.
html
Step 6
standby [group-number] track
object-number [decrement
[priority-decrement]]
Configure HSRP to track an object and change the hot standby priority based
on the state of the object.
• (Optional) group-number—Enter the group number to which the
tracking applies.
• object-number—Enter a number representing the object to be tracked.
The range is from 1 to 500; the default is 1.
• (Optional) decrement priority-decrement—Specify the amount by
which the hot standby priority for the router is decremented (or
incremented) when the tracked object goes down (or comes back up).
The range is from 1 to 255; the default is 10.
Step 7
end Return to privileged EXEC mode.
Step 8
show standby Verify the standby router IP address and tracking states.
Step 9
copy running-config startup-config (Optional) Save your entries in the configuration file.
Command Purpose
To Next Page
Loading...
Need help?
General