EasyManuals Logo

Cisco Catalyst 3120 User Manual

Cisco Catalyst 3120
1224 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #638 background imageLoading...
Page #638 background image
31-12
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
Chapter 31 Configuring System Message Logging
Configuring System Message Logging
Beginning in privileged EXEC mode, follow these steps to enable configuration logging:
This example shows how to enable the configuration-change logger and to set the number of entries in
the log to 500.
Switch(config)# archive
Switch(config-archive)# log config
Switch(config-archive-log-cfg)# logging enable
Switch(config-archive-log-cfg)# logging size 500
Switch(config-archive-log-cfg)# end
This is an example of output for the configuration log:
Switch# show archive log config all
idx sess user@line Logged command
38 11 unknown user@vty3 |no aaa authorization config-commands
39 12 unknown user@vty3 |no aaa authorization network default group radius
40 12 unknown user@vty3 |no aaa accounting dot1x default start-stop group
radius
41 13 unknown user@vty3 |no aaa accounting system default
42 14 temi@vty4 |interface GigabitEthernet4/0/1
43 14 temi@vty4 | switchport mode trunk
44 14 temi@vty4 | exit
45 16 temi@vty5 |interface GigabitEthernet5/0/1
46 16 temi@vty5 | switchport mode trunk
47 16 temi@vty5 | exit
Configuring UNIX Syslog Servers
The next sections describe how to configure the UNIX server syslog daemon and how to define the UNIX
system logging facility.
Logging Messages to a UNIX Syslog Daemon
Before you can send system log messages to a UNIX syslog server, you must configure the syslog
daemon on a UNIX server. This procedure is optional.
Command Purpose
Step 1
configure terminal Enter global configuration mode.
Step 2
archive Enter archive configuration mode.
Step 3
log config Enter configuration-change logger configuration mode.
Step 4
logging enable Enable configuration change logging.
Step 5
logging size entries (Optional) Configure the number of entries retained in the configuration
log. The range is from 1 to 1000. The default is 100.
Note When the configuration log is full, the oldest log entry is removed
each time a new entry is entered.
Step 6
end Return to privileged EXEC mode.
Step 7
show archive log config Verify your entries by viewing the configuration log.

Table of Contents

Other manuals for Cisco Catalyst 3120

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco Catalyst 3120 and is the answer not in the manual?

Cisco Catalyst 3120 Specifications

General IconGeneral
BrandCisco
ModelCatalyst 3120
CategorySwitch
LanguageEnglish

Related product manuals