CHAPTER
30-1
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
30
Configuring RMON
This chapter describes how to configure Remote Network Monitoring (RMON) on the switch. Unless
otherwise noted, the term switch refers to a standalone switch and to a switch stack.
RMON is a standard monitoring specification that defines a set of statistics and functions that can be
exchanged between RMON-compliant console systems and network probes. RMON provides you with
comprehensive network-fault diagnosis, planning, and performance-tuning information.
Note For complete syntax and usage information for the commands used in this chapter, see the “System
Management Commands” section in the Cisco IOS Configuration Fundamentals Command Reference,
Release 12.2.
This chapter consists of these sections:
• Understanding RMON, page 30-1
• Configuring RMON, page 30-2
• Displaying RMON Status, page 30-6
Understanding RMON
RMON is an Internet Engineering Task Force (IETF) standard monitoring specification that allows
various network agents and console systems to exchange network monitoring data. You can use the
RMON feature with the Simple Network Management Protocol (SNMP) agent in the switch to monitor
all the traffic flowing among switches on all connected LAN segments as shown in Figure 30-1.
To Next Page
Loading...
Need help?
General