Cisco Catalyst 3120 - Page 1194

Index
IN-24
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
key distribution center
See KDC
L
l2protocol-tunnel command 16-13
LACP
Layer 2 protocol tunneling
16-9
See EtherChannel
Layer 2 frames, classification with CoS
36-2
Layer 2 interfaces, default configuration 10-16
Layer 2 protocol tunneling
configuring
16-10
configuring for EtherChannels 16-14
default configuration 16-11
defined 16-8
guidelines 16-12
Layer 2 traceroute
and ARP
47-13
and CDP 47-12
broadcast traffic 47-12
described 47-12
IP addresses and subnets 47-13
MAC addresses and VLANs 47-13
multicast traffic 47-13
multiple devices on a port 47-13
unicast traffic 47-12
usage guidelines 47-12
Layer 3 features 1-11
Layer 3 interfaces
assigning IP addresses to
38-7
assigning IPv4 and IPv6 addresses to 39-15
assigning IPv6 addresses to 39-14
changing from Layer 2 mode 38-7, 38-71, 38-72
types of 38-5
Layer 3 packets, classification methods 36-2
LDAP 4-2
LEDs, switch
See hardware installation guide
Lightweight Directory Access Protocol
See LDAP
line configuration mode
2-3
Link Aggregation Control Protocol
See EtherChannel
Link Failure, detecting unidirectional
18-8
Link Layer Discovery Protocol
See CDP
link local unicast addresses
39-4
link redundancy
See Flex Links
links, unidirectional
28-1
link state advertisements (LSAs) 38-31
link-state protocols 38-3
link-state tracking
configuring
37-24
described 37-22
LLDP
configuring
characteristics
27-4
default configuration 27-3
globally 27-5
on an interface 27-5
disabling and enabling
globally
27-5
on an interface 27-5
monitoring and maintaining 27-7
overview 27-1
supported TLVs 27-2
switch stack considerations 27-2
transmission timer and holdtime, setting 27-4
LLDP-MED
configuring
27-3
configuring TLVs 27-6
monitoring and maintaining 27-7
overview 27-1, 27-2
supported TLVs 27-2
LLDP Media Endpoint Discovery
See LLDP-MED