Cisco Catalyst 3120 User Manual

22-16
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
Chapter 22 Configuring Dynamic ARP Inspection
Displaying Dynamic ARP Inspection Information
To clear or display dynamic ARP inspection statistics, use the privileged EXEC commands in
Table 22-3:
For the show ip arp inspection statistics command, the switch increments the number of forwarded
packets for each ARP request and response packet on a trusted dynamic ARP inspection port. The switch
increments the number of ACL or DHCP permitted packets for each packet that is denied by source
MAC, destination MAC, or IP validation checks, and the switch increments the appropriate failure count.
To clear or display dynamic ARP inspection logging information, use the privileged EXEC commands
in Table 22-4:
For more information about these commands, see the command reference for this release.
Table 22-3 Commands for Clearing or Displaying Dynamic ARP Inspection Statistics
Command Description
clear ip arp inspection statistics Clears dynamic ARP inspection statistics.
show ip arp inspection statistics [vlan
vlan-range]
Displays statistics for forwarded, dropped, MAC
validation failure, IP validation failure, ACL
permitted and denied, and DHCP permitted and
denied packets for the specified VLAN. If no
VLANs are specified or if a range is specified,
displays information only for VLANs with
dynamic ARP inspection enabled (active).
Table 22-4 Commands for Clearing or Displaying Dynamic ARP Inspection Logging Information
Command Description
clear ip arp inspection log Clears the dynamic ARP inspection log buffer.
show ip arp inspection log Displays the configuration and contents of the dynamic ARP
inspection log buffer.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English