Cisco Catalyst 3120 User Manual

34-40
Cisco Catalyst Blade Switch 3120 for HP Software Configuration Guide
OL-12247-01
Chapter 34 Configuring Network Security with ACLs
Displaying IPv4 ACL Configuration
You can also display information about VLAN access maps or VLAN filters. Use the privileged EXEC
commands in Table 34-3 to display VLAN map information.
show ip interface interface-id Display detailed configuration and status of an interface. If IP is enabled
on the interface and ACLs have been applied by using the ip access-group
interface configuration command, the access groups are included in the
display.
show running-config [interface interface-id] Displays the contents of the configuration file for the switch or the
specified interface, including all configured MAC and IP access lists and
which access groups are applied to an interface.
show mac access-group [interface interface-id]
Displays MAC access lists applied to all Layer 2 interfaces or the specified
Layer 2 interface.
Table 34-2 Commands for Displaying Access Lists and Access Groups (continued)
Command Purpose
Table 34-3 Commands for Displaying VLAN Map Information
Command Purpose
show vlan access-map [mapname] Show information about all VLAN access maps or the
specified access map.
show vlan filter [access-map name | vlan vlan-id] Show information about all VLAN filters or about a specified
VLAN or VLAN access map.

Cisco Catalyst 3120 Specifications

General

Brand	Cisco
Model	Catalyst 3120
Category	Switch
Language	English