Figure 122: Removing the Power Cassette Module from the Chassis
What to do next
• Replace the Power Cassette Module (if required).
• Position the front power entry bezel on the chassis. Insert and tighten the two screws using a 3/16"
flat-blade torque screwdriver with a torque of 5-7 in-lb (0.56-0.79 Nm) to secure the bezel.
Cisco Converged Broadband Routers Hardware Installation Guide
197
Maintaining the Power System in the Cisco cBR Chassis
Removing the Power Cassette Module from the Cisco cBR Chassis
To Next Page
Loading...
