Introduction
This chapter describes how to set up and operate the Model GS7000
Optical Hub. These procedures assume the hub is installed
according to the procedures in Chapter 2 of this manual.
Network Requirements
Refer to your network design diagrams during setup. The design
diagrams should specify the exact input and output signal levels
required for your network.
In This Chapter
 Tools and Test Equipment ................................................................... 44
 AC Entry Module .................................................................................. 45
 Optical Passive Modules ...................................................................... 46
 Optical Amplifier (EDFA) Modules ................................................... 53
 Optical Amplifier Power In and Power Out Test Point Use
and Operation ....................................................................................... 70
 Optical Switch Module ........................................................................ 72
 Status Monitor/Local Control Module .............................................. 77
 Power Supply Module ......................................................................... 80
 Hub Architecture Examples ................................................................ 84
To Next Page
Loading...
